Configuring multiple v4 addresses on an interface is a kludge, typically only used on hosts which apply inter-network routing logic. It’s an explicit, primary function of the standard v6 specifications.
With v4, you would use either RFC1918 and NAT, or plumb a public address to the host.
With v6 you should use a ULA and an address with a public prefix, and selectively open ports/services to on appropriate address.
An example is the file sharing and administration daemons on my NAS are only bound to its ULA. I don’t need to worry whether it will accidentally be exposed publicly through fat fingering my firewall config, because it will never route beyond my gateway.
Configuring multiple v4 addresses on an interface is a kludge, typically only used on hosts which apply inter-network routing logic. It’s an explicit, primary function of the standard v6 specifications.
With v4, you would use either RFC1918 and NAT, or plumb a public address to the host.
With v6 you should use a ULA and an address with a public prefix, and selectively open ports/services to on appropriate address.
An example is the file sharing and administration daemons on my NAS are only bound to its ULA. I don’t need to worry whether it will accidentally be exposed publicly through fat fingering my firewall config, because it will never route beyond my gateway.